5 Axis Drilling Machine for Hair Brush
This clip follows a single drilling cycle on a five-axis machine set up for hair-brush handles, close enough to see how the head approaches the work and how the swarf is taken away.
The spindle comes down onto a handle clamped in a pocket fixture, drills, and withdraws while the vacuum boot around the nose pulls the chips out of the hole. Because the fixture seats the handle on its own profile rather than on a flat reference face, the hole pattern lands in the same place on every handle in the batch even when the blanks vary a little in section.
The head is the same five-axis unit used across our drilling range: 180 x 180 x 100 mm of travel with 360 degree rotation on the S axis and 30 degrees of tilt on Z, holes from 2 mm to 10 mm at 360 to 420 per minute, and up to 36,000 stored positions. It runs on three-phase 380 V at about 5 kW and weighs around 800 kg.
