2 Axis Tufting Machine

What decides whether a tufting machine produces good work day after day is the fixture rather than the head. This clip is close enough to see how the BHF-225 holds a block: a pocket machined to take the body, and two pneumatic clamps that close on it from either side.

Both working positions carry the same fixture, so the block sits at the same height and the same angle on the load side as on the work side. In the frame one pocket is still empty and grey with its drilled hole array showing, while the other already holds a body filled with yellow bristle — the two halves of the same cycle caught side by side.

Clamping pneumatically rather than by hand also keeps the pressure repeatable, so a thin body is not distorted and a thick one is not left loose. Holes from 2 mm to 10 mm can be filled with filament up to 250 mm at 240 to 360 holes per minute, in anchor or staple mode, in single or double colour, with up to 36,000 positions stored per design.

Contact
97danny@gmail.com