5 Axis Drilling Machine
The part of a drilling machine that gets overlooked is the extraction around the nose, and on this five-axis unit for brush bodies it is a full bellows boot rather than a fixed nozzle.
The boot seals against the block while the drill is inside it, so chips come out of the bore instead of spreading across the work table, and the collar follows the head down as it drills. Below it a formed handle blank sits in a pocket that has been milled to the shape of the body, so the blank is located on its outline rather than on a pin or a corner stop. That is what keeps the hole pattern in the same place when the blanks are moulded or carved instead of sawn square.
The platform is our five-axis drilling head: 180 x 180 x 100 mm of travel, 360 degree rotation on S and 30 degrees of tilt on Z, holes from 2 mm to 10 mm at 360 to 420 per minute, and up to 36,000 stored positions. It runs on three-phase 380 V at about 5 kW and weighs around 800 kg.
